Link to Water Link to Geotechnical Link to Energy Link to Mining

Cement Mill

Cement Mills are designed for light milling, such as float collars, plugs, bridge plugs and retainers. An open pattern cuts quickly on tubular fish and does not easily clog with cement or formation. Cement Mills are faster and more durable when cutting steel than a steel tooth bit, and is recommended for any operation where the alternative is a steel tooth bit.

Cement Mills are available in sizes ranging from 3½ inches to 17½ inches, with fishing necks of 2⅞ inches to 9½ inches.


Bladed Junk Mill

Bladed Junk Mills are dressed with high quality tungsten carbide to ensure optimum performance in every application. Bladed Junk Mills are suitable for all types of general junk milling, as well as the removal of packers, retainers and squeeze tools.

Bladed Junk Mills are available in sizes ranging from 3½ inches to 28 inches, with fishing necks of 2⅞ inches to 11¼ inches.


String Taper Mill

String Taper Mills are ideal for cleaning out damaged casing, liners or tubing, and are also recommended for removing keyseats in open hole. The design tapers from the top and the bottom of the mill, allowing reaming operations from both directions. Pin down and box up connections allow the mill to be run in a drill collar string or combined with a smaller pilot assembly to avoid sidetracking when removing obstructions in casing.

String Taper Mills are available in sizes ranging from 3½ inches to 17½ inches, with fishing necks of 3⅛ inches to 9½ inches.


Taper Mill

Taper Mills are designed specifically for milling through tight spots in tubulars. Heavy crushed carbide dressing increases on-bottom time, while ground OD and stabilizer pads eliminate the risk of cutting through the casing. Taper Mills are recommended for cleaning out liners, tubing and other collapsed or deformed tubulars. They can also be run ahead of other milling tools to clean out "bird nests."

Taper Mills are available in sizes ranging from 3½ inches to 17½ inches, with fishing necks of 3⅛ inches to 9½ inches.